TASCAM Sonicview 24XP / TASCAM Sonicview 24dp firmware v2.3.2

< New functions >

• A function to hide error/alert messages at the top of the screen has been added.

Minimize/Hide can be selected by tapping the left end of the message display area.

< Maintenance items >

• The lock behavior of GPIO-IN and Foot Switch on the LOCK SETUP screen has been changed. Previously, the system ignored input signals from the connectors, but now it locks the APPLY operation on the USER DEFINED CONTROLS Screen (GPIO-IN / Foot Switch), preven​ting setting changes.
• The EQ function would sometimes not operate correctly when the HI band TYPE was set to LPF in a CH module. This has been fixed.
• PTP-related error/alert messages could not be cleared even after the error/alert was resolved. This has been fixed.
• The GATE/EQ/COMP display area on the HOME Screen would appear with a white hash pattern. This has been fixed.
• In the ST IN1/2 module, the R channel assignment for INPUT A would not be applied correctly. This has been fixed.
• When recalling All System Data, the SRC settings for channels 1-2 on the IF-AE16 would not be applied correctly in some cases. This has been fixed.
• When recalling a snapshot with PORT-to-PORT settings, if the Metering Point was set to OUTPUT, the OUTPUT module level meters (LCD only) would stop responding. This has been fixed.
• Settings would not be applied to the R channels of ST IN 1/2 during D.Trim Batch Setup. This has been fixed.
• Inserting a USB/SD card containing WAV files​ of 3 channels or more could cause a control software error. This has been fixed.
• When the following monitor sources were selected in the MONITOR SOURCE ASSIGN screen, selecting the corresponding source from MONITOR SELECT resulted in no monitor audio output. This has been fixed.
• When MON 2L or MON 2R was selected in the MONITOR 1 SOURCE ASSIGN screen
• When MON 1L or MON 1R was selected in the MONITOR 2 SOURCE ASSIGN screen