TASCAM Sonicview 24XP / TASCAM Sonicview 24dp firmware v2.3.1

< New functions >

• Supported the power-redundant models TASCAM Sonicview 16dp / 24dp and added the following functions:
• Added the POWER REDUNDANCY CHECK switch to turn the alert message on/off and show the voltage statuses to the Preferences screen.
• Added the POWER indicators that show the voltage statuses to the upper right of the INFORMATION screen.
• Added power status items to ERROR/ALERT and INFORMATION on the GPIO-OUT page.
• Added power status-related messages to error/alert messages.

Note: These functions are exclusive to power-redundant model​s. However, Parameter2 "OFF" in INFORMATION > Power Status on the GPIO-OUT page is also available on single power supply models TASCAM Sonicview 16/24.

• In User Key / Foot Switch / GPIO-IN settings, the "METER SETUP" option has been added to Parameter2 of Screen > METER.
• On the Network Setup screen, the initial password has been changed to a unique password for each unit.

Note: Units shipped with firmware versions earlier than V2.3.1 are not affected by this change.

< Maintenance items >

• On the HOME screen SEND area, when AUTO MIXER was displayed and WEIGHT was selected, changing the SEND area display still allowed the WEIGHT value to be adjusted using the LCD knob. This has been fixed.
• When the MIX module OUTPUT was set to Dante and the Metering Point was set to OUTPUT, the meters on the OVERVIEW screen or channel screen might not function correctly. This has been fixed.
• SB-16D settings mi​ght not be correctly reflected when recalling All System Data or Snapshots. This has been fixed.
• Assignment of the built-in RECORDER can now be enabled on the MIX module OUTPUT PORT SELECT screen.
• The Routing screen has been updated: tapping an item on the OUTPUT PORT page will transition to the OUTPUT MODULE tab.
• For Mute Status on the GPIO-OUT page, Parameter3 "Unmute - Closed" has been renamed to "Mute-Open," and the ON/OFF conditions for AND and OR have been reversed.
• In User Key / Foot Switch / GPIO-IN settings, the "Toggle" option has been added to Parameter2 of Input Source > ALL.
• When recalling Snapshots, Layer Key colors might not be correctly reflected. This has been fixed.
• In CH25–32 modules, noise could occur on the MIX module outputs under the following conditions. This has been fixed.
• DELAY set to ON and DELAY TIME greater than 0 msec
• DELAY POINT set to PRE FADER
• PRE/POST SETTINGS set to PRE
• Operation stability has been improved.