TASCAM Sonicview 24XP / TASCAM Sonicview 24dp firmware v2.1.0

< New functions > More items can now be controlled using Embe​r+. The main items are as follows.

• ANALOG GAIN / PAD / PHANTOM settings for input ports
• D.TRIM / PHASE / OSC / DIRECT OUT / DELAY / DCA ASSIGN / STEREO LINK settings for CH 1-40 modules
• D.TRIM / PHASE / OSC / DCA ASSIGN / STEREO LINK settings for ST IN 1-2 modules
• INPUT LEVEL / MIX LEVEL / OUTPUT LEVEL / DCA ASSIGN / MODE&IMAGE settings for FX RTN 1-4 modules
• DELAY / DCA ASSIGN / STEREO LINK settings for MIX 1-22 buses
• DELAY / DCA ASSIGN settings for MAIN L/R bus
• LABEL setting for each module/bus/port
• SEND LEVEL / ON/OFF / PRE/POST settings
• AUDIO FOLLOW VIDEO related settings
• TALKBACK/RETURN TALKBACK related settings
• MONITOR related settings
• OSCILLATOR related settings
• Dante related settings
• USER KEY / GPIO-IN/OUT / FOOT SW related settings
• SNAPSHOT related settings
• MODULE LIBRARY related settings

< Maintenance items >

• When recalling a snapshot​, the analog input signal would sometimes momentarily increase in volume. This has been fixed.
• The unit would fail to connect to the SB-16D on rare occasions. This has been fixed.
• Operation stability has been improved.