TASCAM Sonicview 24XP / TASCAM Sonicview 24dp firmware v2.0.0

< New functions >

• Compatibility with the TASCAM IF-ST2110 card has been added.
• SNMP is now supported. The MIB file can be downloaded from the TASCAM website.
• Some functions can now be controlled using Ember+.
• AUTO MIXER function has been added.
• LABEL SETUP function has been added, allowing for the following operations.
• Any name can now be given to input/output ports.
• A mode has been added that allows the module name display to be switched to the port name display.
• Return talkback function has been added.
• The AVAILABLE MEMORY item has been added to the INFORMATION screen.

The amount of available memory that can be used by the system can be checked.

• A dedicated mode for fader and touch panel calibration has been added.
• Mute Group Priority function has been added. This allows the priority to be set for either CH Mute or Mute Group when mute is OFF.
• DCA Mute Priority function has been added. When DCA Mute is turned off, th​e priority for either CH Mute or DCA Mute can be set.
• DCA Solo Priority function has been added. When DCA Solo is turned off, the priority for either CH Solo or DCA Solo can be set.
• The Monitor Status item has been added to the USER DEFINED CONTROLS Screen GPIO-OUT page.

This allows the current monitor state to be output from GPIO-OUT.

• Latch/Unlatch has been added to Parameter 3 of AFV>Trigger Source Emulate on the USER DEFINED CONTROLS page.

< Maintenance items >

• A Control Software Error would appear. This has been improved.

Since this symptom was caused by the following factors, the firmware has been fixed.

• When All System Data (extension .asd4) created with a previous firmware version was loaded using firmware V1.7.0, a Control Software Error might be displayed.
• When All System Data for Sonicview 24 that includes “LCD R” in the USER DEFINED CONTROLS settings Parameter was loaded using Sonicview 16, a Control Software Error might be displayed.
• Factory Reset did not reset the bui​lt-in Dante settings. This has been fixed.
• When saving a current snapshot with a USER KEY, the snapshot name would be “User Key + number”. This has been fixed.
• When non-straight routing (routing where the channel numbers do not match between the Dante Controller and the SB-16D) was performed in Dante Controller, the SB-16D port number display of the output modules could be different from the setting. This has been fixed.
• The Snapshot Module Safe function for the modules to which the SB-16D ports were assigned did not work correctly. This has been fixed.

This symptom, which occurred when the following settings were made, has been fixed with a firmware update.

• When non-straight routing was performed
• When assigned to ST IN 1/2 right channel
• When assigned via SLOT 1/2
• When recording with the internal recorder with no source selected for the right channel, the right channel meter would fluctuate. This has been fixed.
• When there was a difference between the GND of the external device connected to the unit and the GND of the unit, the input PAD would operate, reducing the signal level by -20dB. This has been fixed.
• When the DELAY POINT was set to PRE FADER, the delay would be applied to PFL-Solo and Pre Fader Send. This has been fixed.
• The Main R signal was sent to the COMP Key-in of the MIX module. This has been fixed.
• When the Stereo Link setting was made while the RTA meter of the EQ/GEQ was displayed, the RTA meter would not be displayed correctly. This has been fixed.
• Even if Mute Group and DCA were set to Snapshot Recall Safe, the Mute ON state of each module enabled by Mute Group and DCA would not be maintained. This has been fixed.
• Operation stability has been improved.