TASCAM Sonicview 16XP / TASCAM Sonicview 16dp firmware v1.6.1

< Maintenance items >

• A Control ​Software Error would appear. This has been improved.

Since this symptom was caused by the following factors, the firmware has been fixed.

• When performing a quick operation with User Key/GPIO-IN for storing/recalling Snapshots, a communication error could occur in the system, resulting in a Control Software Error message.
• Improper initial settings inside the system could cause a Control Software Error to occur.
• Unauthorized access to memory could occur on rare occasions, resulting in a Control Software Error or incorrect information being displayed on the LCD screen.
• Memory leaks had occurred, and after a long period of use, a Control Software Error or noise on the LCD screen could occur.
• When a DCA was assigned to another DCA, the audio level did not follow it. This has been fixed.
• When a MIX bus was selected as a monitor source, monitor sound could not be heard unless a port was assigned to the output of that MIX bus. This has been fixed.
• When Snapshot Recall was executed, the Module Safe settings of the DCA/ mute groups were no​t reflected correctly. This has been fixed.
• The PAD setting of a CH module did not work on rare occasions. This has been fixed.
• When "Slow" was selected in the Solo/Mute/Fader Speed setting, it was extremely slow to follow the audio level. This has been fixed.
• Master module assignments were changed even when "DCA/MUTE GROUP/CUSTOM LAYER/LAYER SETUP" was checked on the Snapshot Recall Safe screen. This has been fixed.
• When Snapshot or All System Data was loaded, DCA level settings were not always reflected correctly. This has been fixed.
• When SOLO Mode was set to Exclusive, the monitor sound was not heard correctly when DCA's SOLO was turned on. This has been corrected.