TASCAM Sonicview 16XP / TASCAM Sonicview 16dp firmware v1.5.2

< Maintenance items >

• The following issu​es occurring with firmware V1.5.0 have been fixed:

(both malfunctions occurred when the sampling rate on Dante Settings is set at 48kHZ only)

• Audio was not output on channels 33 and later of the built-in Dante port. This has been fixed.
• On the Dante SETUP I/O Device tab, when mounting an SB-16D unit as the 3rd or later Mounted Device, the port name on the IF-DA64 inserted in SLOT1/2 would change to SB-16D. This has been fixed.

(Noise only would occur when the Dante Settings sampling rate was set at 48 kHz, and the Clock Master on the SYNC CLOCK screen was set on Internal)

• Some noise would occur on the output audio of the internal Dante. This has been fixed.
• The following issues occurring when assigning the built-in Dante port to DIR​ECT OUT on the CH Module have been fixed:

(only when the sampling rate on Dante Settings is set at 48kHz)

• Audio signals were output even when DIRECT OUT was set to OFF. This has been fixed.
• Fixed the issue with DIRECT OUT TRIM as it wouldn’t work properly.
• The following issues would occur when the MODULE Library was recalled. This has been fixed.
• The Φ and DUCKER RELEASE settings of the MIX 1-22 and MAIN L/R modules would affect the audio of the CH1-23 modules.
• The Φ settings of the ST IN 1-2 and MAIN R modules would affect the audio of the MIX1-2 and CH23 modules.