microHAM u2R firmware
microHAM · u2R · u2R · Accessory
Latest firmware for the microHAM u2R is v3.5 (August 9, 2018).
Changelog
u2R firmware changelog
Firmware history
All versions below were published by microHAM on microham.com. Third-party and modified firmware is never listed.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- pttOutActive added to PTT Monitor
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- support for keyer mode control independent on focus
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- Added possibility to set software PTT and software lock from router.
- If band data outputs and focus control outputs on ACC are controlled from control protocol they are left unchanged on USB disconnect instead of switching them to default.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- optional AZERTY keyboard layout
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- new optional feature FSK stuffing: Gaps in FSK stream from computer are adaptively filled with letter or figure shifts to achieve continuous stream.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- Now FSK can be generated at 45.45 Bd instead of aproximate 45 Bd.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- Support to PTT monitor
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- bug fixed: "Restore serial CW" didn't work.
-
PTT lead timing is now consistently applied based on current mode, not initiation method. — summary by updatemystuff.com
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- PTT lead can be applied in two different ways:
(1) PTT is delayed to PA/LNA PTT (2) PTT is started simultaneously with PA/LNA PTT and CW is delayed Up to this version the second case was used only when PTT was initiated by WinKey or serial CW.
In all other cases (like foot switch, serial PTT, WK command PTT ...) the first way was used.
Since this version it is performed consistently with the current mode.
The second case is used in CW mode and the first case in all other modes regardless of what initiates PTT.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- WinKey parameter "1st extension" is controlled automatically now.
If PTT output is not generated the 1st extension is utilized to take account of new parameter T/R delay. The "Keying compensation" is always cleared.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- bug fixed: Status of PTT from radio 2 was incorrectly reported.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- Support to MMVARI FSK sending in RTTY mode added
- Headphones switching settings was changed. Stereo signal now switches between two sets of settings.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- bug fixed: When "Use WinKey PTT" was unchecked audio was not correctly switched.
- bug fixed: When "Use WinKey PTT" was unchecked PTT IN forced manual TX audio state
- bug fixed: Audio switching glitch at the end of paddle send
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- bug fixed: Reading of FH-2 keypad was not functional.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- semi-automatic focus control
- PTT IN handling
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- First release of u2R firmware.
Watch the u2R for updates
Get an email the moment microHAM publishes new firmware. Just your email — no account or password needed.