microHAM micro KEYER III firmware
microHAM · micro KEYER III · micro KEYER III · Accessory
Latest firmware for the microHAM micro KEYER III is v2.12 (May 4, 2021).
Changelog
micro KEYER III firmware changelog
Firmware history
All versions below were published by microHAM on microham.com. Third-party and modified firmware is never listed.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- support for new TI 24-bit ADC
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- IC-9700 and IC-9700(SAT) was merged.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- IC-9700 (SAT) added to the list
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- fixed problem with spurious additional USB device
- minimum required system voltage reduced to 12V
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- bug fixed: mismatch between PC and MK3 clock caused corrupted bytes in longer WinKey messages
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- bug fixed: Responses to commands MD0 and MD1 from FTdx101D was interpreted incorrectly.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- display driver enhancement
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- OLED screensaver added
- IC-9700 and FTdx101D added to the list
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- TS-890 added to the list
- fixed problem with MIC in right channel in SPDIF-Tx
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- bug fixed: In some situations when "Same band radio protection" on coupled SMD was active keyer used to cut start of CW signal.
- fixed label EXT/MAIN MIC shown on the display
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- fixed problem with SPDIF-Tx
- both SPDIF-Tx and SPDIF-Rx levels can be controlled
- RXM/RXS control toggling in main screen
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- changed charge pump source to eliminate birdies on 6m band
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- fixed Linux/PulseAudio issues
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- improved WinKey startup sequence
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- Fixed TX clipping issue
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- fixed timing in communication with OLED display
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- Sleep mode support for OLED display.
-
Source:
microham.comRelease notes & downloadShow release notes Hide release notes
- First release of MK3 derived from MK2 v6.13.
Watch the micro KEYER III for updates
Get an email the moment microHAM publishes new firmware. Just your email — no account or password needed.