Specifications
G106 specifications
- Type
- Amateur HF transceiver
- Frequency range
- TX: 10-80 m + WARC / RX: 0.55-30 / 88-108 MHz
- Modes
- TX: AM / SSB / CW / RX: AM / SSB / CW / WFM
Show the full specification Hide the full specification
General
- Mode
- TX: AM / SSB / CW RX: AM / SSB / CW / WFM
- Type
- Amateur HF transceiver
- Weight
- 720 g (1.59 lb)
- Power supply
- 9-15 VDC (Barrel connector, center positive)
- Tuning steps
- ? KHz
- Other features
- Electronic keyer. Spectrum scope.
- Frequency range
- TX: 10-80 m + WARC RX: 0.55-30 / 88-108 MHz
- Dimensions (W*H*D)
- 120*40*135 mm (4.72*1.58*5.32")
- Frequency stability
- ±1.5 ppm @ 25°C (77°F), within 30 minutes after power on
- Repeater shift / offset
- No
- Antenna impedance / connector
- 50 ohm / BNC
- Current drain / power consumption
- RX: 370 mA TX: Max 2.8 A
Miscellaneous
- Manufactured
- China, 2022-202x
Receiver Section
- Sensitivity
- AM: 10 uV (10 dB S/N) SSB: 0.5 uV (10 dB S/N) CW: 0.25 uV (10 dB S/N)
- Receiver system
- SDR architecture 16 bit sampling
- AF output power / speaker
- 300 mW at ?% distortion / ? ohm
Transmitter Section
- RF output power
- Pwr AM:5 W SSB (PEP):5 W CW:5 W Nominal output power @ 13.8 VDC
- Spurious emissions
- Better than -50 dB
- Microphone input level
- ? mV
- Max FM deviation (Factory set)
- No FM
- Microphone impedance / connector
- ? ohm / 4-pin (Modular)
Changelog
G106 firmware changelog
Firmware history
All versions below were published by Xiegu on xiegu.eu and xiegu.com. Third-party and modified firmware is never listed.
-
Adds CI-V speaker switching, improves AGC and I/Q algorithms; TX frequency extension will be lost on update. — summary by updatemystuff.com
Source:
xiegu.euRelease notes & downloadShow release notes Hide release notes
Xiegu G106 Firmware Update 1.4 build 01 (June 18, 2025).
- Improved AGC algorithm
- Improved I/Q balance algoritm
- Added CI-V command to switch between built-in/external speakers:
– 1D 02 01 [XX]
– XX=0: Built-in speaker – XX!=0: External speaker(MIC handle speaker) NOTICE: If you have a TX frequency extension applied to your G106 you will loose the extension when updating to v1.4.
If you like to retain the extension please create a support ticket and refer to your order number for further information.
-
Source:
xiegu.euRelease notes & downloadShow release notes Hide release notes
Xiegu G106 Firmware Update 1.3 build 03 (May 9, 2023).
Watch the G106 for updates
Get an email the moment Xiegu publishes new firmware. Just your email — no account or password needed.
