SmallHD PageOS firmware v6.3.5

Supported series: FALCON - 500 Series, FALCON - 700 Series, FIAT - 700 Series, FOCUS - 700 Series, Other Services, Others Important Software Information: PLEASE READ BELOW

• OLDER FIRMWARE IS LISTED BELOW, CLICK “SHOW MORE”
• Click Here for a complete list of compatible monitors
• This firmware will NOT support the following ​monitors:
• Focus 5 & 7 (LCD, OLED, HDMI, SDI, & RX/TX)

- 2403 HDR & 2403 HB

• 1703 HDR & 1703 Studio
• 1303 Studio
• 700 Series - 701, 701L, 702 Bright, 702 OLED
• 500 Series - 501, 502, 502 Bright
• This firmware is NOT compatible with the DSMC3 RED®Touch, or Action 5
• RED® Touch users have firmware available on the RED® Touch tab
• This firmware is NOT compatible with legacy monitors (DP1, DP6, DP4, AC7, and

DP7-PRO)

• If your firmware is below 3.6.5, we recommend the following upgrade path:

3.6.5 -> 4.8.7 -> 5.5.6 -> 6.0.0 Improvements and Alterations:

• Timecode & Start/Stop Metadata can now be transmitted over Teradek Bolt links
• Changes to the White Point Offset are now shown in the Color Pipe Bugs Fixed:
• Fixed the “flashing” effect that was happening when Monitor Settings was set to Interlace > Bob (4K Production Monitors, Ultra 7, Ultra 10)
• Resolved an issue using custom Fal​se Color Maps while in Portrait Orientation
• Fixed an intermittent problem preventing Waveform data from displaying
• Dial LEDs will no longer flicker at low brightness
• Resolved an issue preventing Dial labels from appearing at times
• “Fixed Nits” option in the Color Pipe is now more accurate for 7-inch monitors

Known Issues

• Quantum 32 Waveform has sparkly artifacts in the Waveform data
• This has only been observed on a small percentage of units Recommended Practices
• Connect external recorders directly downstream of your source device (i.e. camera), not downstream of the monitor