AnyTone AT-D868UV firmware
AnyTone · AT-D868UV · AT-D868UV · Handheld
Latest firmware for the AnyTone AT-D868UV is v2.40 (November 30, 2021).
Specifications
AT-D868UV specifications
- Type
- Amateur VHF/UHF transceiver
- Frequency range
- 136-174 / 400-480 MHz
- Modes
- FM / NFM / DMR (Tier I & II)
Show the full specification Hide the full specification
General
- Mode
- FM / NFM / DMR (Tier I & II)
- Type
- Amateur VHF/UHF transceiver
- Weight
- 282 g (9.95 oz), with 2100 mAh battery pack and antenna
- Power supply
- 7.4 VDC (Li-Ion battery pack)
- Tuning steps
- 2.5 / 5 / 6.25 / 10 / 12.5 / 20 / 25 / 30 / 50 KHz
- Other features
- DMR APRS (TX only). 1.7" TFT display. Auto-sense DMR or FM reception. GPS.
- Frequency range
- 136-174 / 400-480 MHz
- Dimensions (W*H*D)
- 61*129*39 mm (2.4*5.08*1.54")
- Frequency stability
- ? ppm
- Channels / memory management
- 4000 regular 10000 talk groups 200000 contacts
- Antenna impedance / connector
- 50 ohm / SMA
- Current drain/power consumption
- RX: ? mA TX: ? A
Miscellaneous
- Manufactured
- China, 2017-201x (Discontinued)
Receiver Section
- Selectivity
- FM: 70 dB (Adjacent channel) NFM: 60 dB (Adjacent channel)
- Sensitivity
- FM: 0.25 uV (12 dB SINAD) NFM: 0.35 uV (12 dB SINAD) DMR: 0.3 uV (BER 5%)
- AF output power / speaker
- 1 W at 5% distortion / 16 ohm
Transmitter Section
- RF output power
- HighMidLow 1Low 2 2 m:7 W5 W2.5 W1 W 70 cm:6 W5 W2.5 W1 W
- Modulation system
- DMR: 4FSK
- Spurious emissions
- Better than -36 dB
- Microphone input level
- ? mV
- Max FM deviation (Factory set)
- FM: ±5 KHz NFM: ±2.5 KHz
- Microphone impedance / connector
- ? ohm / ?-pin
Changelog
AT-D868UV firmware changelog
-
v2.40first tracked
Firmware history
All versions below were published by AnyTone on anytone.net and qixiang.com. Third-party and modified firmware is never listed.
-
Source:
anytone.netRelease notes not published by vendor — see official page.
Release notes & download
Watch the AT-D868UV for updates
Get an email the moment AnyTone publishes new firmware. Just your email — no account or password needed.
