DJI Digital FPV System firmware v01.00.00.00

?

• Added ability to set the storage mode of the air unit or the goggles as Overwrite or Stop When Full.
• Added ability to set the protocol between the air unit and flight co​ntroller as Normal (S.Bus) or DJI HDL.
• Added display for public channel (CH8).
• Added firmware detection. A prompt will appear on the goggles if the firmware of the air unit, goggles and remote controller are not the same version.
• Fixed occasional issue: the remote controller was unable to unlock a third-party flight controller.
• Removed alert when the remote controller is in the public channel.
• Optimized the screen display when entering live view.
• Optimized the loading speed of files when entering playback.
• Optimized the battery level detection of the goggles.
• Optimized the viewing experience in Audience mode.
• Optimized the screen display of remote controller during calibration.

Notice:

• Restart the air unit, goggles, and remote controller once the update is complete.
• Make sure that the firmw​are of the air unit, the goggles and the remote controller are in the same version.

Check the firmware version in Setting, Device Info, and then Device Info on goggles.

• If the firmware update fails, restart the device and DJI Assistant 2 (DJI FPV Series), and try updating again.
• Restart the air unit after setting the protocol between the air unit and flight controller.