DJI FlyCart 100 firmware v01.20.16.02

Aircraft:

• Supported D-RTK 3 Multifunctional Station in Relay Station and Base Station modes.
• Supported PSDK, allowing third-party devices with E-Port Lite to configure custom controls using PSDK.
• Supported DJI DeliveryHub cloud platform.
• Supported to use DJI Battery Incubator with the aircraft battery.
• Supported to swap functions​ between the left and right dials on the remote controller.
• Aircraft used with the flagship winch system support DJI AirSense and are able to detect flight information broadcast by manned aircraft equipped with ADS-B (Automatic Dependent Surveillance- Broadcast) transmitters and issue alerts.
• Supported safety clip installation detection in dual battery mode.
• Supported to import KML/KMZ flight route files into DJI DeliveryHub, or into the remote controller using a microSD card. When using a microSD card, the file storage path is DJI/systemRoute.
• Optimized payload collision prevention. Note that payload collision prevention is an assistive feature.

During operation, avoid flying near obstacles as possible.

If payload collision prevention is triggered DJI FlyCart 100 Release Notes https://​www.dji.com/flycart-100 during a route operation, you need to manually operate the aircraft to bypass the obstacle.

DO NOT tap the Continue button in Operation View directly, as this may cause the aircraft or cargo collision.

• Fixed occasional issue where task records were lost in Dual Controller mode.
• Fixed occasional abnormal limitation issues with vertical speed.
• Fixed occasional issue failure of the limited speed near ground feature.
• Fixed occasional lagging issue of the remote controller.
• Fixed other known issues.