DJI A3 firmware v1.7.0.5

? Firmware:

• F1 to F8 cha​nnel values for the flight controller will now remain unchanged after remote controller is signal lost.
• Added SDK activation through DJI Assistant 2.
• Added GPS information recording when taking stills with a third-party camera connected to a Ronin-MX.
• Added support for SBUS receiver of low data frequency.
• Optimized the switching mechanism for the redundancy system.
• Optimized the judging method for flight status.
• Optimized GPS information encoding.
• Optimized redundant ESC signal transmission detection.
• Optimized motors initialization.
• Optimized the way the aircraft takes off.
• Fixed incorrect altitude control definitions in the SDK.
• Fixed an issue where whitelisted No Fly Zones couldn’t be unlocked.
• Fixed an issue that maximum attitude angle couldn’t be reached in Attitude Mode.

Assistant 2:

• Added Control Performance Parameters in Gain page.
• Added Start Motor button and Start Method option in ESC Setting page.

Notes

• When us​ing the D-RTK, be sure to upgrade to this firmware version.

DJI A3 Release Notes http://www.dji.com/a3

• Ensure that the Lightbridge 2 Air System and Ground System are on the latest firmware version.
• Use the latest version of DJI Assistant 2 to configure the flight controller.
• Flight controller settings will be reset after firmware upgrade. Remember to reconfigure the settings.
• When using the A3 Pro, be sure to upgrade all modules, i.e. the IMU Pro, flight controller, etc.
• Upgrade your iOSD MARK II firmware before use.

DJI A3 Release Notes http://www.dji.com/a3