Apache Labs ANAN-10E firmware

Apache Labs · ANAN-10E · ANAN-10E · SDR transceiver

Latest firmware for the Apache Labs ANAN-10E is v1.3 (September 7, 2016).

Specifications

ANAN-10E specifications

Figures for the Anan-10.

Show the full specification

Mode: Depending on software
Type: Amateur HF/VHF SDR transceiver
Weight: ? Kg (? lb)
Power supply: 13.8 VDC
Tuning steps: Depending on software
Other features: Supports seven fully independent receivers (software dependent) Each receiver can display 48/96/192/384/1152 KHz of spectrum. Full duplex, any split over the entire range. Full QSK. Transverter output. Ethernet connection.
Frequency range: TX: 10-160 m + WARC / 6 m RX: 0.01-55 MHz
Dimensions (W*H*D): ? mm (?")
Frequency stability: ±? ppm
Repeater shift / offset: Depending on software
Channels / memory management: Depending on software
Antenna impedance / connector: 50 ohm / Three BNC
Current drain / power consumption: RX: ? mA TX: Max ? A

RF output power: Max 15 W
Spurious emissions: Better than -? dB
Microphone input level: ? mV
Max FM deviation (Factory set): Direct conversion
Microphone impedance / connector: ? ohm / 3-pin (Phantom voltage for electret mike, switchable)

Changelog

All versions below were published by Apache Labs on apache-labs.com. Third-party and modified firmware is never listed.

Get an email the moment Apache Labs publishes new firmware. Just your email — no account or password needed.