ACOM 700S

ACOM 700S firmware

ACOM · ACOM 700S · ACOM 700S · Amplifier

Latest firmware for the ACOM 700S is v2.3 (July 16, 2025).

ACOM 700S firmware changelog

  1. v1.9 v2.3 CAT-controlled ATU tuning now supports listen-only CAT with improved stability and error handling

  2. v1.8 v1.9

  3. v1.6 v1.8 Adds active automatic protection feature, improves CAT interface control, disables auto-operation after hard faults.

  4. v1.0 v1.6

  5. v1.0 first tracked

Firmware history

All versions below were published by ACOM on acom-bg.com. Third-party and modified firmware is never listed.

  1. Version 2.3 Latest Released Jul 16, 2025 First seen Sep 7, 2026

    CAT-controlled ATU tuning now supports listen-only CAT with improved stability and error handling — summary by updatemystuff.com

    Source: acom-bg.com

    Show release notes
    • Improve stability during CAT-controlled ATU tune
    • Make the ATU Tune process work with listen-only CAT
    • ​Fix ATU tune with unidirectional (listen-only) CAT
    • Retry CAT commands only when the radio does not respond
    • Try not to switch to manu​al tune mode when CAT error detected
    • Do not hardcode 100 mic level maximum for TS-990 and similar
    • Properly save the radio mic gain before tuning
    • Always report band number in telemetry messages
    Release notes & download
  2. Version 1.9 Released Mar 21, 2024 First seen Sep 13, 2026

    Source: acom-bg.com

    Show release notes
    • Only internal code changes The​se changes are purely ​internal and have no effect on end-user experience
    Release notes & download
  3. Version 1.8 Released Feb 19, 2024 First seen Sep 13, 2026

    Adds active automatic protection feature, improves CAT interface control, disables auto-operation after hard faults. — summary by updatemystuff.com

    Source: acom-bg.com

    Show release notes
    • NEW function: "Active automatic protection"
    • CAT interface: properly set power before tune
    • Increase threshold for 5​V max
    • YAESU CAT interface: restore MIC gain after tune
    • Improve code readab​ility and add HW division (These changes are purely internal and have no effect on end user experience)
    • Disable Auto-Operate after Hard Fault Error
    • Fix: selection of polling time and byte spacing
    Release notes & download
  4. Version 1.6 Released May 19, 2022 First seen Sep 13, 2026

    Source: acom-bg.com

    Show release notes

    Small firmware imp​rovements based on m​inor hardware changes;

    Release notes & download
  5. Version 1.0 First seen Sep 13, 2026

    Source: acom-bg.com

    Show release notes

    Base firmware version;

    Release notes & download

Watch the ACOM 700S for updates

Get an email the moment ACOM publishes new firmware. Just your email — no account or password needed.

More ACOM amplifiers we track